OPC Logo

Polychem 7528-M-60 (Z8206)

Polychem 7528-M-60 is an vinyl toluene modified alkyd supplied at 60% in a narrow cut aliphatic hydrocarbon solvent, providing a flash point of greater than 100 degrees F, but at the same time allowing for faster dry than standard mineral spririt cuts. This product is low-HAP and can be formulated into HAP-free coatings (below 1% HAP).

CHARACTERISTICS SPECIFICATIONS
Percent Non Volatile 60
Viscosity, G-H Z2-Z4
Acid Number 12
Gardner Color 6 Maximum
Weight Per Gallon 7.65 ± 0.1
Solvent Quick Drying Mineral Spirits
Modifier VT
Oil Soybean Oil
Reduced Viscosity F-H
Reduced NVM 40
Reduction Solvent Quick Drying Mineral Spirits
Clarity CLEAR TO SLIGHTLY HAZY

 

SUGGESTED USES
Aerosols
Metal furniture and toy finishes
Floor sealers

 

DRIER RECOMMENDATIONS (% metal on total binder solids)
Cobalt 0.03%
Calcium 0.02%
Zirconium 0.30%
The information and specifications stated here are for the material currently offered, are subject to change without prior notice, and due to variations in user handling and application methods should not be relied upon without testing under user conditions. The supplier makes no warranty of any kind, express or implied, concerning this product or its use either singly or in combination with other substances. User assumes all risks incident to its use. User must communicate to employees and customers all warnings that relate to the potential exposure to this product. The user assures that workplace and disposal practices are in compliance with laws, regulations and ordinances. ALL WARRANTIES, INCLUDING WARRANTIES OR MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, ARE EXPRESSLY EXCLUDED. IN NO EVENT SHALL THE SUPPLIER BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES

Copyright © 2013 OPC Polymers. All rights reserved.

Printed from http://www.opcpolymers.com on 11/29/2021